Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Front

WARNING: This page is about a different car, the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Tahoe, 2013 Chevrolet Suburban, and 2013 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing - Front

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Ensure the bearing is installed squarely into the bearing bore.
1	Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly Procedure Ensure the printing on the bearing is facing upward. A suitable adapter is required to use with the J 8092 driver. Press the bearing until the bearing bottoms on the front case half. Special Tools J 2619-01 Slide Hammer J 8092 Universal Driver J 44737 Shift Rail Bearing Remover For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure
Ensure the bearing is installed squarely into the bearing bore.

Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly

Procedure

Ensure the printing on the bearing is facing upward.
A suitable adapter is required to use with the J 8092 driver.
Press the bearing until the bearing bottoms on the front case half.

Special Tools

J 2619-01 Slide Hammer
J 8092 Universal Driver
J 44737 Shift Rail Bearing Remover

For equivalent regional tools, refer to Special Tools .