Component Replacement - Conversion from First Design to Second Design
WARNING: This page is about a different car, the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Tahoe, 2013 Chevrolet Suburban, and 2013 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
It is possible to repair a first-design assembly using second-design components. Refer to the parts catalog and the tables above for component part number clarification.
NOTE:
First-design LD components are shown in the view above.
When servicing a first-design assembly with second-design components, the following components MUST be replaced as a group:
- Front Case Half Assembly - with internal gear and retaining ring
- Locking Plate
- Thrust Washer (front)
- Input Shaft
- Pilot Bearing
- Thrust Washer (rear)
- Planetary Carrier Assembly
- High/Low Clutch