LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Repair Instructions >> Radiator Replacement (Non HP2)

Radiator Replacement (Non HP2)

Fig 1: View Of Radiator Assembly & Bolts (Non HP2)
GM1698713Courtesy of GENERAL MOTORS COMPANY
Radiator Replacement (Non HP2)

Callout Component Name

Preliminary Procedure

  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
  2. Remove surge tank hose/pipe. Refer to Radiator Surge Tank Inlet Hose/Pipe Replacement (Non-HP2) , Radiator Surge Tank Inlet Hose/Pipe Replacement (HP2) .
  3. Remove radiator hose inlet. Refer to Radiator Inlet Hose Replacement (Non-HP2) , Radiator Inlet Hose Replacement (HP2) .
  4. Remove radiator hose outlet. Refer to Radiator Outlet Hose Replacement (Non-HP2) , Radiator Outlet Hose Replacement (HP2) .
  5. Remove cooling fan and shroud. Refer to Cooling Fan and Shroud Replacement (Non-HP2) , Cooling Fan and Shroud Replacement (HP2) .
  6. Remove engine oil cooler pipe/hose quick connect. Refer to Engine Oil Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  7. Remove transmission oil cooler lines. Refer to Transmission Fluid Cooler Hose/Pipe Replacement .
1 Radiator Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
25 N.m (18 lb ft)
2 Radiator Assembly
scientia non olet · About LEMON Manuals