Instrument Cluster Replacement (Cadillac)

Fig 1: View Of Instrument Panel Cluster Assembly, Bolts & Screws (Cadillac)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the instrument panel cluster trim plate bezel. Refer to Instrument Cluster Trim Panel Replacement (Cadillac) . NOTE: Before removing the instrument cluster, use SPS programming support tool to capture the odometer information. This captured data will then need to be programmed into the NEW instrument cluster. Refer to Instrument Cluster Programming and Setup .
1	Instrument Panel Cluster Assembly Bolts/Screw (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 2 (18 lb in)
2	Instrument Panel Cluster Assembly Procedure Disconnect electrical connections. A replacement cluster must be programmed. Refer to Control Module References .

Callout

Component Name

Preliminary Procedure
Remove the instrument panel cluster trim plate bezel. Refer to Instrument Cluster Trim Panel Replacement (Cadillac) .

NOTE:

Before removing the instrument cluster, use SPS programming support tool to capture the odometer information. This captured data will then need to be programmed into the NEW instrument cluster. Refer to Instrument Cluster Programming and Setup .

Instrument Panel Cluster Assembly Bolts/Screw (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
2 (18 lb in)

Instrument Panel Cluster Assembly

Procedure

Disconnect electrical connections.
A replacement cluster must be programmed. Refer to Control Module References .