Rear Brake Hose Replacement (Frame to Rear Axle JH6)

Fig 1: View Of Rear Brake Hose Components (Frame to Rear Axle JH6)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to Brake Dust Warning . WARNING: Refer to Brake Fluid Irritant Warning . Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Brake Pipe Fitting (Qty: 2) CAUTION: Refer to Fastener Caution . Procedure Remove any dirt or debris from the brake pipe fitting. Cap the brake pipe fitting to prevent brake fluid loss and contamination. Tighten 25 N.m (18 lb ft)
2	Hose Bracket to Frame Bolt (Qty: 2) Tighten 25 N.m (18 lb ft)
3	Brake Pipe Fitting (Qty: 2) Procedure Remove any dirt or debris from the brake pipe fittings. Cap the brake pipe fittings to prevent brake fluid loss and contamination. Tighten 25 N.m (18 lb ft)
4	Hose to Rear Axle Bolt Tighten 25 N.m (18 lb ft)
5	Rear Brake Hose Assembly Procedure Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) , Hydraulic Brake System Bleeding (Two-mode Hybrid) , Hydraulic Brake System Bleeding (Manual) .