Sunroof Panel/Window Garnish Molding Replacement (Crew Cab)
Courtesy of GENERAL MOTORS COMPANY Sunroof Panel/Window Garnish Molding Replacement (Crew Cab)
| Callout |
Component Name |
| 1 |
Sunroof Panel/Window Garnish Molding Assembly
- Tilt molding approximately 45 degrees with rear end up.
- Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs.
- Grab front of molding at centerline and pull rearward approximately 1 inch.
- Push front edge up, locking front tabs in place.
- Push up on outboard edges of molding to secure.
- After molding is secured, slide the molding forward until it stops.
|