Rear Seat Riser Finish Cover Replacement (with HP2)

Fig 1: View Of Rear Seat Riser Finish Covers (HP2)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Turn the ignition switch to the off/lock position, remove the ignition key and secure in technicians pocket until procedure is complete. Flip and fold the rear seat forward.
1	Rear Seat Frame Outer Finish Cover Procedure Pull upward to disengage the retainer clips.
2	Rear Seat Riser Finish Cover Procedure Pull upward to disengage the 4 retainer clips on the left side of the cover and then disengage the 3 top retainer clips. For reinstallation use the 3 locators to align part properly. Engage upper and lower front clips to the back edge of rear seat frame front finish cover. To finish installation process move rearward along the cover. Part is properly installed when all edges are aligned with rear seat frame front finish cover.

Callout

Component Name

Preliminary Procedure

Turn the ignition switch to the off/lock position, remove the ignition key and secure in technicians pocket until procedure is complete.
Flip and fold the rear seat forward.

Rear Seat Frame Outer Finish Cover
Procedure
Pull upward to disengage the retainer clips.

Rear Seat Riser Finish Cover
Procedure

Pull upward to disengage the 4 retainer clips on the left side of the cover and then disengage the 3 top retainer clips.
For reinstallation use the 3 locators to align part properly.
Engage upper and lower front clips to the back edge of rear seat frame front finish cover. To finish installation process move rearward along the cover. Part is properly installed when all edges are aligned with rear seat frame front finish cover.