Shock Absorber Replacement (2500 Series)

Fig 1: View Of Shock Absorber Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Shock Absorber Retaining Nut CAUTION: Refer to Fastener Caution . TIP: Support the lower control arm with a safety stand. Tighten 24 N.m (17 lb ft)
2	Insulator (Qty: 2) Install the lower insulator, which is smaller than the upper insulator and plastic pilot ring. Install the upper insulator, which is the larger of the 2 insulators.
3	Retaining Nut Tighten 80 N.m (59 lb ft)
4	Mounting Bolt
5	Shock Absorber TIP: If replacing the shock absorber, refer Shock Absorber Disposal for the proper disposal procedure.