LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1889 (Antilock Brake System - Non-Hybrid Greater Than/Equal To 3900 Kg (8600 Lb) GVW) >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon XL and 2012 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The wheel speed sensor ring is integral to the wheel hub and must be replaced as an assembly.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement (1500 Series) , Rear Brake Rotor Replacement (2500 Series) .
  4. Remove the rear axle hub. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
scientia non olet · About LEMON Manuals