Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement

WARNING: This page is about a different car, the 2008 GMC Yukon XL and 2008 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Yaw Sensor, Electrical Connector & Retaining Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the passenger seat. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) .
1	Yaw Sensor Nut (Qty: 2) NOTE: Refer to Fastener Notice . Tip: Lift the floor carpet to gain access to the yaw sensor. Tighten: 7 N.m (62 lb in)
2	Yaw Sensor
3	Yaw Sensor Electrical Connector Procedure: Disconnect the electrical connector.