Tail Lamp Replacement (GMC Yukon Two-Mode Hybrid)
Tail Lamp Replacement (GMC Yukon Two-Mode Hybrid)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Open the liftgate in order to access the tail lamp assembly screws. |
|
| 1 | Tail Lamp Assembly Screw (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in) |
| 2 | Tail Lamp Electrical Harness Assembly Connector TIP: Disconnect the tail lamp bulb and side marker lamp bulb sockets from the lamp assembly. |
| 3 | Tail Lamp Assembly TIP: Upon installation, push inward on the outer edge of the tail lamp in order to seat the 2 locating pins to the outer body panel nuts. |