Rear Fog Lamp Replacement (Cadillac Export)

Fig 1: View Of Tail Lamp Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Rear Fog Lamp Replacement (Cadillac Export)

Callout	Component Name
Preliminary Procedure  Open the liftgate in order to access the left tail lamp assembly screws.
1	Tail Lamp Assembly Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten  2 N.m (18 lb in)
2	Tail Lamp Assembly Locator Pin (Qty: 2) TIP:  Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts.
3	Tail Lamp Retainer Nut (Qty: 2)
4	Tail Lamp Wiring Harness Assembly Connector
5	Tail Lamp Assembly The bottom bulb in the left tail lamp is the rear fog lamp bulb and will have a red lens. This is an export only item. Upon installation, push inward on the tail lamp in order to seat the 2 locating pins.