LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade ESV RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - BW 4485 (Nr3)) >> Repair Instructions - On Vehicle >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transfer Case Adapter, Bolts & Seal
    GM652614Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Always use a new seal for the adapter. Do not use any type of sealant or adhesive in place of or with the seal.

  1. Install a NEW seal onto the adapter.
    2. NOTE:

    The transfer case adapter must be installed so that the adapter is evenly seated to the transmission before installing the retaining nuts.

  2. Install the adapter.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the adapter bolts.

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  4. Install the transmission mount.
  5. Install the transfer case. Refer to Transfer Case Assembly Replacement .
scientia non olet · About LEMON Manuals