LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade ESV RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - BW 4485 (Nr3)) >> Repair Instructions - On Vehicle >> Front Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Seal Installation Special Tools
    GM1728904Courtesy of GENERAL MOTORS COMPANY
  1. Install the J 43484  installer (2) to the GE-8092  handle (1).
  2. Install a NEW seal onto J 43484  installer.
  3. Using J 43484  installer (2), and GE-8092  handle (1), install the seal.
  4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
  5. Check the fluid level. Add fluid, if necessary.
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals