LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade ESV RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1897 (Transfer Case - Mp 3023/3024 (NQH)) >> Repair Instructions - Off Vehicle >> Transfer Case Assemble >> Front Output Shaft Assembly, Drive Chain, Actuator Shaft Gear, and Oil Pump Suction Pipe Installation

Front Output Shaft Assembly, Drive Chain, Actuator Shaft Gear, and Oil Pump Suction Pipe Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Output Shaft Assembly, Drive Chain, Actuator Shaft Gear, Oil Pump Suction Pipe & Seal
GM1849369Courtesy of GENERAL MOTORS COMPANY
Front Output Shaft Assembly, Drive Chain, Actuator Shaft Gear, and Oil Pump Suction Pipe Installation

Callout Component Name
1 Transfer Case Front Output Shaft Assembly, Transfer Case Front Output Shaft Drive Chain Assembly
NOTE:
  • Install the chain with darkened links up.
  • Install the front output shaft assembly into the front case half while engaging the chain with the drive sprocket.
2 Transfer Case Actuator Shaft Gear
3 Transfer Case Oil Pump Suction Pipe Seal
NOTE:
  • Use a NEW seal.
  • Lubricate the seal to ease installation.
  • Install the seal to the pipe prior to inserting the pipe into the pump.
4 Transfer Case Oil Pump Suction Pipe O-ring
5 Transfer Case Oil Pump Suction Pipe
scientia non olet · About LEMON Manuals