LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade Base, AWD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Antilock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Rear Wheel Speed Sensor
    GM2178528Courtesy of GENERAL MOTORS COMPANY
  1. Install the wheel speed sensor (1) to the rear axle.
    2. Fig 2: Identifying Rear Wheel Speed Sensor Bolt
    GM2178527Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
    3. Fig 3: Identifying Rear Wheel Speed Sensor Electrical Connector & Harness Clips
    GM2178526Courtesy of GENERAL MOTORS COMPANY
  3. Connect the wheel speed sensor electrical connector (1).
  4. Install the wheel speed sensor electrical connector and sensor harness clips (2) to the inboard frame rail.
  5. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals