Shock Absorber Replacement (2500)

Fig 1: Shock Absorber (2500, 3500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Rear Shock Absorber Bolt (Qty: 2) Procedure Disconnect the Electronic Suspension Control electrical connector, if equipped. Support the rear drive axle with a suitable jack stand.
2	Rear Shock Absorber Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 115 N.m (85 lb ft)
3	Rear Shock Absorber