Rear Bumper Fascia Replacement (Avalanche, Cadillac EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Bumper Fascia & Retainers

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear wheelhouse inner panel extensions. Refer to Wheelhouse Liner Panel Replacement - Rear . Remove the side rear bumper step pads. Refer to Step Pad Replacement - Side Rear Bumper (Avalanche, Cadillac EXT) . Remove the center rear bumper step pad. Refer to Step Pad Replacement - Center Rear Bumper (Avalanche, Cadillac EXT) .
1	Rear Fascia Plastic Retainers (Qty: 2)
2	Rear Fascia Tip: Be sure to disconnect any electrical connectors before attempting the removal of the fascia.

Callout

Component Name

Preliminary Procedures

Remove the rear wheelhouse inner panel extensions. Refer to Wheelhouse Liner Panel Replacement - Rear .
Remove the side rear bumper step pads. Refer to Step Pad Replacement - Side Rear Bumper (Avalanche, Cadillac EXT) .
Remove the center rear bumper step pad. Refer to Step Pad Replacement - Center Rear Bumper (Avalanche, Cadillac EXT) .

Rear Fascia Plastic Retainers (Qty: 2)

Rear Fascia
Tip: Be sure to disconnect any electrical connectors before attempting the removal of the fascia.