LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1746 (Antilock Brake System - Greater Than Or Equal To 3900 Kg (8600 Lb) GVW) >> Diagnostic Information and Procedures >> StabiliTrak Indicator Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2011 GMC Cab & Chassis Sierra, 2011 Chevrolet Suburban, and 2011 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the multifunction switch assembly-I/P.
  2. Test for infinite resistance between the signal terminal 1 and the ground terminal 3 with the switch in the open position.
    • If less than infinite resistance 

      Replace the multifunction switch assembly-I/P

    • If infinite resistance 
  3. Test for less than 2 Ω between the signal terminal 1 and the ground terminal 3 with the switch in the closed position.
    • If 2 Ω or greater 

      Replace the multifunction switch assembly-I/P

    • If less than 2 Ω 
  4. All OK.
scientia non olet · About LEMON Manuals