Rear Bumper Fascia Replacement (Avalanche, Cadillac EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Bumper Fascia & Retainers

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear wheelhouse inner panel extensions. Refer to Rear Wheelhouse Panel Liner Replacement (RPO X88 Chevrolet, RPO O88 GMC) or Rear Wheelhouse Panel Liner Replacement (RPO HP2) . Remove the side rear bumper step pads. Refer to Rear Bumper Step Outer Pad Replacement (Avalanche, Cadillac EXT) . Remove the center rear bumper step pad. Refer to Rear Bumper Step Center Pad Replacement (Avalanche, Cadillac EXT) .
1	Rear Fascia Plastic Retainers (Qty: 2)
2	Rear Fascia IMPORTANT: The spare tire hoist access cover bezel will be destroyed when removing the fascia. The bezel must be replaced. Tip: Be sure to disconnect any electrical connectors before attempting the removal of the fascia.

Callout

Component Name

Preliminary Procedures

Remove the rear wheelhouse inner panel extensions. Refer to Rear Wheelhouse Panel Liner Replacement (RPO X88 Chevrolet, RPO O88 GMC) or Rear Wheelhouse Panel Liner Replacement (RPO HP2) .
Remove the side rear bumper step pads. Refer to Rear Bumper Step Outer Pad Replacement (Avalanche, Cadillac EXT) .
Remove the center rear bumper step pad. Refer to Rear Bumper Step Center Pad Replacement (Avalanche, Cadillac EXT) .

Rear Fascia Plastic Retainers (Qty: 2)

Rear Fascia

IMPORTANT: The spare tire hoist access cover bezel will be destroyed when removing the fascia. The bezel must be replaced.

Tip: Be sure to disconnect any electrical connectors before attempting the removal of the fascia.