Circuit/System Testing

Verify that DTC U2142 is not set.
- If the DTC is set, refer to DTC U2105-U2199 .
Verify that DTC C0710 is not set.
- If the DTC is set, refer to DTC C0710 .
Ignition OFF, disconnect the harness connector at the yaw/lateral accelerometer sensor.
Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 10 Ω between the ground circuit terminal 1 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
Disconnect the harness connector at the EBCM.
Test for infinite resistance between the 12 V reference circuit terminal 32 of the EBCM connector and ground.
- If not the specified value, test the 12 V reference circuit for a short to ground.
Test for less than 2 Ω between the 12 V reference circuit terminal 32 of the EBCM connector and terminal 4 of the yaw/lateral accelerometer sensor connector.
- If greater than the specified range, test the 12 V reference circuit for open/high resistance.
If all circuits test normal, replace the yaw/lateral accelerometer sensor. If the DTC resets, replace the EBCM.