LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> Escalade Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1390 (Engine Controls And Fuel - Hybrid (Hp2) 6.0L (LFA) - Troubleshooting & Diagnosis) >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the Service Bay Test aborts or fails a DTC will NOT be set.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Select the Service Bay Test with the scan tool.
    4. WARNING: Refer to Road Test Warning .
  4. Follow the instructions on the scan tool.
    • If the test aborts, correct the condition for running the test and then retest.
    • If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
  5. Verify that the EVAP I/M system status is set to YES.
scientia non olet · About LEMON Manuals