Inflatable Restraint Passenger Presence System Replacement - Front

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Passenger Presence System Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Rezeroing .
1	Front Seat Recliner Lever (If Equipped) Tip: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.
2	Front Seat Adjuster Outer Finish Cover Refer to Front Seat Cushion Outer Trim Panel Replacement (Power) or Front Seat Cushion Outer Trim Panel Replacement (Manual) .
3	Front Seat Adjuster Inner Finish Cover Refer to Front Seat Cushion Inner Trim Panel Replacement .
4	Front Seat Cushion Cover and Pad Tip: Disengage the j-channel retainers from the seat cushion frame. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
5	Inflatable Restraint Front Passenger Presence Sensor Retainer (Qty: 2)
6	Inflatable Restraint Front Passenger Presence Sensor Tip: Lay the seat on it's side. Unhook connector from retainer on seat frame and push up through seat pan. Disconnect and remove sensor.
7	Front Seat Adjuster Assembly Refer to Front Seat Adjuster Replacement (Manual) or Front Seat Adjuster Replacement (Power) .
8	Inflatable Restraint Front Passenger Presence Module Rivets (Qty: 2) Tip: Drill out the rivets to remove and install using new rivets.
9	Inflatable Restraint Front Passenger Presence Module