Manual Shift Shaft and Seal Replacement
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedures
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the transmission from the vehicle. Refer to Transmission Replacement .
- Remove the transmission fluid pan. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
- Remove the control valve body. Refer to Control Valve Lower Body and Upper Body Replacement .
|
| 1 |
Manual Shift Shaft Pin
Tip:
- Discard the pin. Replace with NEW pin.
- "Walk" the pin out using side cutters.
|
| 2 |
Manual Shaft Detent Lever Hub Pin
Tip:
- Discard the pin. Replace with NEW pin.
- "Walk" the pin out using side cutters.
|
| 3 |
Manual Shift Shaft
Tip:
The manual shaft must be removed to replace the manual shaft seal. |
| 4 |
Manual Shift Shaft Seal
Tip:
- Use the J 45201
Cooler Line Seal Remover, to remove the seal from the transmission case. See Special Tools .
- Use the J 43909
Selector Shaft Seal Installer, to install the seal into the transmission case.
|