Torque Converter Housing with Fluid Pump Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | NEW Fluid Pump Seal |
| 2 | Torque Converter (with Fluid Pump) Housing Assembly
NOTE:
Ensure the turbine shaft (O-ring) seal is not installed prior to installing the torque converter housing assembly. The seal may become cut or damaged during installation of the torque converter housing assembly.
|
| 3 | Bolts M10 x 50 (Qty: 9)
NOTE:
Refer to Fastener Notice
. Procedure: Tighten in the sequence shown. Tighten: 72 N.m (53 lb ft) |
| 4 | NEW Turbine Shaft (O-Ring) Seal |