Fluid Pump Cover Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fluid Pump Cover Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Fluid Pump Cover Assembly
2	Fluid Pump Cover Bolts M6 x 40 (Qty: 13) Tip: Hand tighten only.
3	Alignment Tool and Bolt NOTE: Refer to Fastener Notice . Procedure Center the J 46664 around the fluid pump cover assembly in the 9 o'clock position and tighten the alignment bolt. See Special Tools . Tighten the fluid pump cover bolts in the sequence shown. Tighten: 11 N.m (97 lb in) Special Tool: J 46664 Pump Cover Alignment Tool. See Special Tools .
4	NEW 1-2-3-4 and 3-5 Reverse Clutch Housing Thrust Washer