Control Solenoid Valve Assembly Contact Gap Inspection

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inspecting Control Solenoid Valve Assembly Contact Gap

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Control Solenoid (w/Body and TCM) Valve Assembly Tip: Inspect the contact area between the "heat sink" area of the control solenoid valve assembly and the valve body. There should be no visible gap. If a gap exists, loosen all 18 bolts and retighten in the required sequence.