Center Support, Output Carrier and Output Shaft Removal (6L80/6L90)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Center Support Retaining Ring
CAUTION:
Use care when removing or installing the retaining ring. Ensure the J 45126 and DT 47773 are installed properly onto the retaining ring or bodily injury may occur. Tip: To release tension on the retaining ring, place the retaining ring flat on the floor and step on it, then remove the tool. Special Tools
|
| 2 | Center (with 2-6 Low and Reverse Clutch) Support Assembly |
| 3 | Output Carrier Assembly and Output Shaft Assembly
NOTE:
Ensure the DT 47786 is completely threaded into the output shaft assembly. Due to the weight of the assembly, incomplete threading may cause the assembly to break free from the DT 47786, causing component damage. Special Tool: DT 47786 Output Carrier/Shaft Lifting Tool. See Special Tools . |
| 4 | Output Shaft Thrust Bearing Assembly |