1-2-3-4 and 3-5 Reverse Clutch Bearing Assembly Replacement

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing 1-2-3-4 and 3-5 Reverse Clutch Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	3-5 Reverse Clutch Bearing NOTE: Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission. NOTE: Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission. Specification: Install the bearing flush to 0.3 mm below the thrust surface. Special Tools DT 47865 Bearing Remover. See Special Tools . DT 47866 Bearing Installer. See Special Tools . J 8092 Driver Handle J 45124 Removal Bridge. See Special Tools .

Callout

Component Name

3-5 Reverse Clutch Bearing

NOTE: Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission.

NOTE: Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission.

Specification: Install the bearing flush to 0.3 mm below the thrust surface.

Special Tools

DT 47865 Bearing Remover. See Special Tools .
DT 47866 Bearing Installer. See Special Tools .
J 8092 Driver Handle
J 45124 Removal Bridge. See Special Tools .