LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> Escalade Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1233 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Diagnostic Information and Procedures >> Transmission Fluid Cooler Flushing and Flow Test (J 45096) >> Back Flush Procedure

Back Flush Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying J 45096-30
    GM1762577Courtesy of GENERAL MOTORS CORP.
  1. Connect the J 45096-30  (1) to the vehicle transmission oil cooler supply and return lines at the transmission. See Special Tools .
    2. Fig 2: Identifying Black Supply Hose & Clear Waste Hose
    GM1762584Courtesy of GENERAL MOTORS CORP.
  2. Connect the black supply hose (1) to the return line, top connector of the transmission, and the clear waste hose (2) to the feed line, bottom connector of the transmission, to the vehicle cooler lines. This is the reverse flow - backflush direction.
    3. Fig 3: Setting Main Function Switch To FLUSH Position
    GM1212339Courtesy of GENERAL MOTORS CORP.
  3. Turn the main function switch to the FLUSH position. Allow the machine to operate for 30 seconds.
    4. Fig 4: Setting Main Function Switch To IDLE Position
    GM1212341Courtesy of GENERAL MOTORS CORP.
  4. Turn the main function switch to the IDLE position and allow the supply vessel pressure to dissipate.
scientia non olet · About LEMON Manuals