LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> Escalade Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1191 (Vehicle Diagnostic Information (2 Of 2)) >> Diagnostic Repair Verification

Diagnostic Repair Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install any components or connectors that have been removed or replaced during diagnosis.
  2. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
  3. Clear the DTCs.
  4. Turn OFF the ignition for 60 seconds.
  5. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List - Vehicle  and perform the appropriate diagnostic procedure.

    Or

    If the repair was symptom related, duplicate the conditions under which the customer concern occurred to verify the repair. If the customer concern reoccurs, return to Symptoms - Vehicle  and perform the appropriate symptom diagnostic.

scientia non olet · About LEMON Manuals