Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Body Lock Pillar Garnish Molding Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable roof rail SIR system. Refer to SIR Disabling and Enabling . Remove rear side door sill plate. Refer to Rear Side Door Sill Plate Replacement (Standard Wheelbase) or Rear Side Door Sill Plate Replacement (Extended Wheelbase) .
1	Body Lock Pillar Garnish Molding Plug
2	Body Lock Pillar Garnish Molding Screw NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Removable Midgate Hinge Finish Cover
4	Rear Belt Assembly Anchor Bolt Tighten: 70 N.m (52 lb ft)
5	Body Lock Pillar Garnish Molding Assembly Tighten: 43 N.m (32 lb ft) Tip: Remove seat belt D-ring from the adjuster assembly. Route seat belt through garnish molding.
6	Body Lock Pillar Garnish Molding Retainers (Qty: 5)