LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> DTS 4.6 6 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Open Assist Rod Stud Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Upper Hood Assist Rod Ball Stud
    GM105286Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the upper hood assist rod ball stud (2) to the hood (1).

    Tighten 

    Tighten the upper hood assist rod ball stud (2) to 9 N.m (80 lb in).

  2. Press the hood assist rod onto the upper hood assist rod ball stud (2).
  3. Ensure that the clip is fully seated on the hood assist rod.
    4. Fig 2: View Of Lower Hood Assist Rod Ball Stud & Fender
    GM130509Courtesy of GENERAL MOTORS COMPANY
  4. Install the lower hood assist rod ball stud (1) to the fender (2).

    Tighten 

    Tighten the lower hood assist rod ball stud (1) to 24 N.m (18 lb ft).

  5. Press the hood assist rod onto the lower hood assist rod ball stud (1).
  6. Ensure that the clip is fully seated on the hood assist rod.
  7. Close the hood.
scientia non olet · About LEMON Manuals