LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - On Vehicle - 2 Of 2) >> Valve Stem Oil Seal and Valve Spring Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing Valve Seal
    GM616165Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the valve stem and the inner diameter of the new seal with clean engine oil.
  2. NOTE: Install a seal protector over the valve stem prior to installing the valve stem seal.
  3. Using a twisting pushing motion install the NEW valve stem seal using the J 38820  . See Special Tools .
  4. Install the valve spring retainer and valve spring.
  5. Fig 2: Base Plate Over Spark Plug Hole
    GM650537Courtesy of GENERAL MOTORS CORP.
    WARNING: Refer to Compressed Valve Spring Warning .
  6. Swing the arm over the valve spring retainer and tighten the swivel nut of the J 44211  (2) down only enough to allow access for installation of the valve locks. See Special Tools .
  7. Using a magnet, position the valve locks to the valve stem retainer groove. Grease can be used to hold the locks in place.
  8. Remove the swivel nut and arm of the J 44211  (2). See Special Tools .
  9. Relieve the air pressure to the cylinder being serviced.
  10. Remove the J 39313  (1) from the spark plug hole.
  11. Remove the base plate of the J 44211  (2). See Special Tools .
  12. Install the spark plug. Refer to Spark Plug Replacement .
  13. Repeat removal steps 7-14 and installation steps 1-11 on any other cylinders being serviced.
  14. Install the right camshafts. Refer to Camshaft Replacement - Right Side .
  15. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  16. Fig 3: Flywheel Holder
    GM1275654Courtesy of GENERAL MOTORS CORP.
  17. Remove the EN 46326  (1). See Special Tools .
  18. Install the starter. Refer to Starter Replacement (LH2) .