LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 2 Of 3) >> Water Outlet Housing Disassemble

Water Outlet Housing Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold Plenum Duct
    GM1041032Courtesy of GENERAL MOTORS CORP.
  1. Loosen the intake manifold plenum duct clamp.
  2. Remove the intake manifold plenum duct.
    3. Fig 2: EVAP Purge Valve & Bolt
    GM1254539Courtesy of GENERAL MOTORS CORP.
  3. Remove the evaporative emission (EVAP) purge valve bolt.
  4. Remove the EVAP purge valve.
    5. Fig 3: MAP Sensor & Bolt
    GM1254541Courtesy of GENERAL MOTORS CORP.
  5. Remove the manifold absolute pressure (MAP) sensor bolt.
  6. Remove the MAP sensor.
    7. Fig 4: Bypass Hose
    GM1254542Courtesy of GENERAL MOTORS CORP.
  7. Remove the bypass hose clamp.
  8. Remove and discard the bypass hose.
    9. Fig 5: Heater Hose Fitting
    GM1254544Courtesy of GENERAL MOTORS CORP.
  9. Remove the heater hose fitting.
    10. Fig 6: Engine Coolant Air Bleed Fitting
    GM1254547Courtesy of GENERAL MOTORS CORP.
  10. Remove the engine coolant air bleed fitting.
  11. Remove the EVAP purge valve and MAP sensor O-rings and discard.
scientia non olet · About LEMON Manuals