LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 2 Of 3) >> Oil Filter Adapter Disassemble (With Oil Cooler)

Oil Filter Adapter Disassemble (With Oil Cooler)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Filter Adapter Components - W/Oil Cooler
    GM1351921Courtesy of GENERAL MOTORS CORP.
  1. Remove and discard the oil filter adapter gasket (1).
  2. Remove and inspect the heat shield bolts (10).
  3. Remove and inspect the heat shield (9).
  4. Remove and inspect the oil pressure switch (8).
  5. Remove and discard the oil pressure switch O-ring (7).
  6. Remove and inspect the oil cooler bypass valve hole plug (2).
  7. Remove and inspect the oil cooler bypass valve (3).
  8. Remove and inspect the oil filter fitting (5).
  9. If necessary, remove and inspect the oil filter bypass valve (6).
scientia non olet · About LEMON Manuals