LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 2 Of 3) >> Intake Manifold Disassemble

Intake Manifold Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold-To-Cylinder Head Gaskets
    GM1012862Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the intake manifold-to-cylinder head sealing gaskets.
  1. Remove and discard the intake manifold-to-cylinder head gaskets.
    2. Fig 2: Sight Shield Retainer Ball Studs
    GM1254532Courtesy of GENERAL MOTORS CORP.
  2. Remove the sight shield retainer ball studs.
    3. Fig 3: Manifold Vacuum Source Cap
    GM1254534Courtesy of GENERAL MOTORS CORP.
  3. Remove the manifold vacuum source cap.
    4. Fig 4: Vacuum Boost Fitting
    GM1254538Courtesy of GENERAL MOTORS CORP.
  4. Remove the vacuum boost fitting.
scientia non olet · About LEMON Manuals