LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 2 Of 3) >> Engine Front Cover Assemble

Engine Front Cover Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Front Cover Fitting
    GM1346220Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the engine front cover fitting and tighten to 25 N.m (18 lb ft).
    2. Fig 2: Thermostat Gasket
    GM1254524Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW thermostat gasket onto the thermostat.
    3. Fig 3: Thermostat & Gasket
    GM1254523Courtesy of GENERAL MOTORS CORP.
  3. Install the thermostat and gasket into the thermostat housing.
    4. Fig 4: Thermostat Housing & Bolts
    GM1254521Courtesy of GENERAL MOTORS CORP.
  4. Install the thermostat housing.
  5. Install the thermostat housing bolts and tighten to 10 N.m (89 lb in).
    6. Fig 5: Water Pump O-Ring
    GM1403356Courtesy of GENERAL MOTORS CORP.
  6. Install the NEW water pump O-ring.
    7. Fig 6: Water Pump & Bolts
    GM1040709Courtesy of GENERAL MOTORS CORP.
  7. Install the water pump.
  8. Install the water pump bolts and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals