LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Throttle Body Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Throttle Body Assembly Electrical Connector
    GM887927Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  3. Disconnect the electrical connector from the throttle body assembly.
    4. Fig 2: Throttle Body Assembly & Bolts
    GM927998Courtesy of GENERAL MOTORS CORP.
  4. Remove the throttle body assembley mounting bolts.
  5. Remove the throttle body and throttle body gasket from the water housing.
  6. Discard the throttle body gasket.
scientia non olet · About LEMON Manuals