LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: MAF/IAT Sensor, Screws & Seal
    GM1201263Courtesy of GENERAL MOTORS CORP.
    CAUTION:
    • Handle the MAF sensor carefully.
    • Do not drop the MAF sensor in order to prevent damage to the MAF sensor.
    • Do not damage the screen located on the air inlet end of the MAF.
    • Do not touch the sensing elements.
    • Do not allow solvents and lubricants to come in contact with the sensing elements.
    • Use a small amount of a soap based solution in order to aid in the installation.
  1. Install a NEW MAF/IAT sensor gasket.
  2. Carefully install the MAF/IAT sensor into the air cleaner housing cover.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the MAF/IAT sensor screws and tighten to 4 N.m (35 lb in).
    4. Fig 2: Air Cleaner Outlet Duct
    GM1201220Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
    5. Fig 3: MAF/IAT Sensor Electrical Connector
    GM1201074Courtesy of GENERAL MOTORS CORP.
  5. Reconnect the MAF/IAT sensor electrical connector.
scientia non olet · About LEMON Manuals