LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Knock Sensor 1 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold & Bolts
    GM928175Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
    2. Fig 2: Knock Sensors & Electrical Connectors
    GM1284306Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the knock sensor (KS) electrical connector (2).
  3. Remove the KS bolt.
  4. Remove the KS (1).
scientia non olet · About LEMON Manuals