LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Ignition Coils
    GM1283865Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure that the spark plug seals are in place when installing the ignition coil.
  1. Install the ignition coil.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the ignition coil retaining bolt and tighten to 10 N.m (89 lb in).
  3. Reconnect the ignition coil electrical connector.
    4. Fig 2: Ignition Coil Cover - Bank 1
    GM1235151Courtesy of GENERAL MOTORS CORP.
  4. Install the ignition coil cover to the cam cover.
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals