LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: HO2S - Bank 2, Sensor 2
    GM1251007Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the oxygen sensor to the exhaust pipe. Tighten the front heated oxygen sensor (HO2S) to 42 N.m (31 lb ft).
  2. Route and attach the wiring as noted during disassembly.
  3. Connect the oxygen sensor electrical connector.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals