LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Chassis to Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: EVAP Hose & Retainers
    GM818893Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP hose to the fuel tank.
  2. Install the chassis to canister evaporative emission (EVAP) hose to the following:
    • The body retainer (1)
    • The 3 retaining features (2) on the fuel tank
    • The retainer clip (3)
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals