LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: EVAP Canister & Retaining Nuts
    GM785820Courtesy of GENERAL MOTORS CORP.
  1. Complete the following in order to install the EVAP canister:
    1. Insert the fresh air tube and tab on the canister forward into the body brace.
    2. Rotate the rear of the canister up over the 2 weld studs on the floor pan.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the EVAP canister retaining nuts and tighten to 6 N.m (53 lb in).
    3. Fig 2: EVAP Hoses At EVAP Canister
    GM785817Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP hoses to the EVAP canister.
  4. Connect the electrical connector to the EVAP canister.
  5. Install the rear frame. Refer to Rear Frame Replacement .
scientia non olet · About LEMON Manuals