LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
    2. Fig 1: Crankshaft Position Sensor & Bolt
    GM928205Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the crankshaft position sensor electrical connector.
  3. Remove the crankshaft sensor retaining bolt.
  4. Remove the crankshaft sensor.
scientia non olet · About LEMON Manuals