LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Position Sensor Electrical Connectors
    GM887907Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
    2. NOTE: When disconnecting more than one sensor, mark the connectors to ensure correct re-installation. The electrical connectors are physically interchangeable, however, they must be installed to the correct sensor.
  2. Disconnect the electrical connector from the left bank intake camshaft position sensor (1).
    3. Fig 2: Camshaft Sensors & Bolts
    GM1247907Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft sensor retaining bolt.
  4. Remove the left bank intake camshaft sensor (3).
scientia non olet · About LEMON Manuals