Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Sensors & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Inspect the camshaft sensor O-ring for wear or damage. If a condition is found, replace the O-ring.

CAUTION: Refer to Fastener Caution .

Install the left bank exhaust camshaft position sensor (4) and retaining bolt and tighten to 10 N.m (89 lb in).

Fig 2: Camshaft Position Sensor Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Reconnect the camshaft sensor electrical connector (2).
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
Operate the engine and inspect the camshaft sensor for engine oil leaks.