LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 4.6L (LH2) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Right Intake Camshaft Position Actuator Solenoid & Bolts
    GM1276389Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the actuator solenoid electrical connector.
  3. Remove the right intake camshaft position (CMP) actuator solenoid bolts.
  4. Remove the right intake CMP actuator solenoid.
scientia non olet · About LEMON Manuals