LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Controls And Fuel - 4.6L (LH2) - DTC P0335 To DTC P2544) >> DTC P2120, P2122, P2123, P2125, P2127, P2128, or P2138 >> Component Test

Component Test

WARNING: This page is about a different variant/trim than selected.

Dynamic Test

  1. Install a 3A fused jumper wire between the 5-volt reference terminal of the applicable APP sensor and 5 volts. Install a jumper wire between the low reference terminal and a ground.
  2. Sweep the sensor through the entire range while monitoring the voltage between the signal terminal and the low reference terminal with a DMM. The voltage should vary between 0.40-4.50 volts with out an spikes or dropouts.
    • If the voltage is not within the specified range or is erratic, replace the accelerator pedal assembly.
scientia non olet · About LEMON Manuals